1. Surfaces to be painted must be free of oil, dust grease, wax and old loosely adhering finish, cracking and scailing paint.
2. Sand surface until wood is smooth to the touch and no silvers or roughness remain.
3. Dust off and wipe using a clean rag then apply one coat of SPHERO FLATWALL ENAMEL.
4. Using a putty knife apply SPHERO GLAZING & SPONT PUTTY on wood surface imperfections such as open wood grains, nail heads, dents, scrtches, shallow dents, etc.
5. Apply two coats of SPHERO QUICK DRYING ENAMEL PAINT
2. Sand surface until wood is smooth to the touch and no silvers or roughness remain.
3. Dust off and wipe using a clean rag then apply one coat of SPHERO FLATWALL ENAMEL.
4. Using a putty knife apply SPHERO GLAZING & SPONT PUTTY on wood surface imperfections such as open wood grains, nail heads, dents, scrtches, shallow dents, etc.
5. Apply two coats of SPHERO QUICK DRYING ENAMEL PAINT
1. Surfaces to be painted must e free of oil, dust, grease, wax and old loosely adhering finish, cracking and scaling paint or other contaminants.
2. For areas afected by molds and mildews, wipe the whole area with a clean rag with a Cholorx solution to remove surface contaminants. Let dry.
3. If existing paint condition is still in good condition, was the surface with water or with a mild detergent solution to remove surface contaminants. Let dry.
4. Apply 1 or 2 coats of SPHERO QDE.
5. If existing paint condition is poor, strip to bre substrate by sanding or wire-brushing. Then apply 1 coat of Sphero Flatwall Enamel.
6. Using a putty knife apply SPHERO GLAZING & SPOT Putty on wood surface imperections such as open wood grains, nail heads, dents, scratches, shallow dents, etc.
7. Apply two coats of SPHERO QUICK DRYING ENAMEL PAINT.
2. For areas afected by molds and mildews, wipe the whole area with a clean rag with a Cholorx solution to remove surface contaminants. Let dry.
3. If existing paint condition is still in good condition, was the surface with water or with a mild detergent solution to remove surface contaminants. Let dry.
4. Apply 1 or 2 coats of SPHERO QDE.
5. If existing paint condition is poor, strip to bre substrate by sanding or wire-brushing. Then apply 1 coat of Sphero Flatwall Enamel.
6. Using a putty knife apply SPHERO GLAZING & SPOT Putty on wood surface imperections such as open wood grains, nail heads, dents, scratches, shallow dents, etc.
7. Apply two coats of SPHERO QUICK DRYING ENAMEL PAINT.
